PlainWater

Washington County, Pennsylvania

SDWIS compliance plate

Sheet PA125 · Washington County 33 sys · 7,539 viol · #1002/3254

VIOL-SEVERE · HEALTH-LOW · RANK-UPPER · PHOTO-FINISH · PFAS-CLEAN · SRC-GW · SYS-SMALL · BOOK-FULL

  • VIOL-SEVERE 90.9% flagged
  • HEALTH-LOW 13.5% health
  • RANK-UPPER #1002/3254
  • PHOTO-FINISH ±0.3 pp
  • PFAS-CLEAN 0.0% detect
  • SRC-GW GW lead 48%
  • SYS-SMALL 33 systems
  • BOOK-FULL 7/7 fields

Nearest flagged-rate peer: Lawrence County ( -0.3 pp flagged-rate)

According to EPA SDWIS county population served used on /counties, Washington County ranks #1,002 of 3,254 counties by people served, and #42 of 68 counties in Pennsylvania. See methodology · corpus placement.

Washington County standing, lower-flagged corpus third

Flagged-system rate 90.9% is at or below the corpus lower third (≤ 92.7% flagged) across 2,973 counties with ≥3 SDWIS systems . Health-based share 13.5% is health-based share in the middle third (≤ 24.5%) . UCMR5 detect rate 0.0% is UCMR5 detect rate at or below the tested-pool lower third (≤ 0.0%) . Population served ranks #1,002 of 3,254 · #42 of 68 in Pennsylvania.

Flagged-rate neighbourhood around Washington County

Lowest/highest poles plus in-state counties nearest Washington County on % of SDWIS systems with ≥1 violation. Full ladder: /counties.

0% 20% 40% 60% 80% 100% Greene · lowest Lawrence · near Butler · near Sullivan · highest 66.7% 89.9% 90.6% 90.9% 91.8% 92.9% 100%

Source: EPA SDWIS (county aggregates) As of 2026-05-15

Water Systems

Compare beyond Pennsylvania

Lower-flagged peers for Washington County

Cross-state counties nearest Washington County on flagged-system share (90.9%) and cumulative violation count (7,539). In-state neighbours stay on the compliance plate above.

Similar flagged-system rate

Nearest cross-state counties by % of SDWIS systems with at least one violation on record.

4 peers

Similar violation load

Nearest cross-state counties by cumulative SDWIS violation count (all systems in the county).

4 peers
Data sourced from EPA SDWIS and UCMR5 PFAS monitoring data. See our methodology for details. Retrieved and formatted by PlainWater

Every figure on PlainWater is rendered directly from EPA SDWIS drinking-water data, no number is typed in by an editor. This page draws directly on EPA SDWIS data, no figure is typed in by an editor. See our editorial standards & corrections policy, the methodology behind these numbers, or report a data error.